Unloader at work often between repair method
Unloader is a use of a wide range of products, most of the practical application of the process will have some problems, I plant after several years of lessons learned, probably tidied unloader will appear in the work of the project in a few a common problem for reference study. Unloader work together for continuous operation promised anyway, during operation if thrown in the axial leakage or ash leakage phenomenon, can imprison binder cover screws, or the new replacement asbestos packing material in the pressing cover to ʱ??
1, the unloader at the factory in order to note a little oil and grease, in normal use, six months after the transmission and bearing parts should supplement or replace the oil, if the installation environment is to reduce excessive dust or high temperatures should be in oil change,
2, unloader work together for continuous operation promised anyway, during operation if thrown in the axial leakage or ash leakage phenomenon, can imprison binder cover screws, or the new replacement material covered in asbestos packing pressed can.
3, if the material is conveyed sticky discharge is too large, easy to overload caused by equipment users run the simple install overload protection device or replace high-power motor.
4, the internal structure of the various models of the stripper are the same order of disassembly and assembly process is basically the same, in the course of transportation discharger should remain stable to avoid the collision, causing damage to housing and motor.
In this paper, issued by the Changzhou Sunflower finishing, For reprint please indicate the sourcehttp://www.jinkuihua178.com/